Here is a list of all functions, variables, defines, enums, and typedefs with links to the files they belong to:

- d -

• D8 : anglerate.h
• data : config.c , transponder.h , config.h
• DATA_TYPE_JPEG_IMAGE : pixhawk.h
• DATA_TYPE_KINECT : pixhawk.h
• DATA_TYPE_RAW_IMAGE : pixhawk.h
• DATA_TYPES : pixhawk.h
• DATA_TYPES_ENUM_END : pixhawk.h
• DBGAFR_LOCATION_MASK : gpio_stm32f10x.c
• DBGAFR_NUMBITS_MASK : gpio_stm32f10x.c
• DBGAFR_POSITION_MASK : gpio_stm32f10x.c
• DBGAFR_SWJCFG_MASK : gpio_stm32f10x.c
• dcm_ki : imu.h
• dcm_kp : imu.h
• DE_ACTIVATE_ALL_BOXES : rc_unittest.cc , rx.cc , rx_ranges_unittest.cc
• deadband3d_high : mixer.h
• deadband3d_low : mixer.h
• debug : debug.c , debug.h , main.c , flight_altitudehold_unittest.cc
• DEBUG16_VALUE_COUNT : debug.h
• DEBUG_PPM_ISR : pwm_rx.c
• DEBUG_SECTION_TIMES : debug.h
• DebugMon_Handler() : stm32_it.c , stm32_it.h
• DECIDEGREES_TO_DEGREES : maths.h
• DECIDEGREES_TO_RADIANS : maths.h , sonar_unittest.cc
• DEFAULT : target.h
• DEFAULT_BAUD_RATE_INDEX : gps.c
• DEFAULT_BLACKBOX_DEVICE : config.c
• DEFAULT_FEATURES : target.h
• default_imu : flight_altitudehold_unittest.cc
• default_mixer : flight_mixer_unittest.cc
• DEFAULT_PWM_RATE : config.c
• DEFAULT_RX_FEATURE : rx.h , target.h
• DEFAULT_SERVO_MAX : mixer.h
• DEFAULT_SERVO_MAX_ANGLE : mixer.h
• DEFAULT_SERVO_MIDDLE : mixer.h
• DEFAULT_SERVO_MIN : mixer.h
• DEFAULT_SERVO_MIN_ANGLE : mixer.h
• default_sonar : sonar.h
• DEFAULT_TELEMETRY_INVERSION : config.c
• DEG2RAD : alignsensor_unittest.cc
• DEGREES_TO_DECIDEGREES : maths.h
• DEGREES_TO_RADIANS : maths.h
• degreesToRadians() : maths.h , maths.c
• DELAY_10_HZ : rx.c
• DELAY_50_HZ : rx.c
• DELAY_5_HZ : rx.c
• detectedMPUSensor_e : accgyro_mpu.h
• detectedSensors : initialisation.c , initialisation.h
• detectHardwareRevision() : hardware_revision.c , hardware_revision.h , hardware_revision.c , hardware_revision.h , hardware_revision.c , hardware_revision.h
• detectMpu() : accgyro_mpu.c , accgyro_mpu.h
• determinePortSharing() : serial.c , serial.h
• devClear() : maths.c , maths.h
• device : blackbox.h
• Device_Descriptor : usb_prop.c
• Device_Property : usb_prop.c
• DEVICE_STATE : usb_pwr.h
• Device_Table : usb_prop.c
• devPush() : maths.c , maths.h
• devStandardDeviation() : maths.h , maths.c
• devVariance() : maths.c , maths.h
• DIGIT_TO_VAL : gps_conversion.c
• dir : ledstrip.c
• DISABLE : platform.h
• DISABLE_MPU6000 : accgyro_spi_mpu6000.c
• DISABLE_MPU6500 : accgyro_spi_mpu6500.c
• DISPLAY : target.h
• displayDisablePageCycling() : display.h
• displayEnablePageCycling() : display.h
• displayInit() : display.h
• displayResetPageCycling() : display.h
• displaySetNextPageChangeAt() : display.h
• displayShowFixedPage() : display.h
• DMA1_CH2_HANDLER : dma.h
• DMA1_CH3_HANDLER : dma.h
• DMA1_CH6_HANDLER : dma.h
• DMA1_CH7_HANDLER : dma.h
• DMA1_Channel2_IRQHandler() : dma.c
• DMA1_Channel3_IRQHandler() : dma.c
• DMA1_Channel4_IRQHandler() : serial_uart_stm32f30x.c
• DMA1_Channel6_IRQHandler() : dma.c
• DMA1_Channel7_IRQHandler() : dma.c
• DMA_ClearFlag() : ws2811_unittest.cc , platform.h
• DMA_Cmd() : platform.h , ws2811_unittest.cc
• DMA_GetFlagStatus() : platform.h , ws2811_unittest.cc
• dmaBufferOffset : ws2811_unittest.cc
• dmaCallbackHandlerFuncPtr : dma.h
• dmaHandlerIdentifier_e : dma.h
• dmaHandlers_t : dma.h
• dmaInit() : dma.c , dma.h
• dmaSetHandler() : dma.c , ws2811_unittest.cc , dma.h
• DMP_MEM_R_W : accgyro_mpu6050.c
• DMP_MEM_START_ADDR : accgyro_mpu6050.c
• doesConfigurationUsePort() : serial.c , serial.h
• DOWNWARDS_THRUST : flight_altitudehold_unittest.cc
• driveNumber : fat_standard.h
• drv_adc_config_t : adc.h
• drv_adxl345_config_t : accgyro_adxl345.h
• drv_pwm_config_t : pwm_mapping.h
• DTERM_AVERAGE_COUNT : anglerate.h
• dterm_cut_hz : anglerate.h
• DUMMY_BYTE : accgyro_l3gd20.c
• DUMP_ALL : cli.c
• DUMP_CONTROL_RATE_PROFILE : cli.c
• DUMP_MASTER : cli.c
• DUMP_PROFILE : cli.c
• dumpFlags_e : cli.c
• dynThrPID : rate_profile.h